Turbine Flow Meter – Axial Turbine Meter (Sanitrary)

Turbine Flow Meter – Axial Turbine Meter (Sanitrary)

Share:


Turbine Flow Meter – Axial Turbine Meter (Sanitrary)



Specifications

Sizes:
" - 8" (4-200 mm)

Accuracy:
0.5%

Temperature:
-4-300°F ( -20 ~ +150℃)

Process Connection:
Sanitary Flanges

Application:
Food and beverage

Viscosity:
1 to 10 cSt

Operating Pressure:
up to 150 psi (10 bar)

Material:
SS #316L (body) 2Cr13 or CD4MCu (rotors) Tungsten Carbide (Bearings)

Signal Output:
4-20mA, pulse, Modbus, HART

Process Medium:
Clean liquids


ALTM turbine flow meters (hereinafter referred to as turbines) are used for the precise measurement of instantaneous flow rates of low- viscosity fluids as tap and demineralized water, fuels, liquefied gases, light fuel oils, solvents, and pharmaceutical fluids. Turbine flowmeters measure volumetric flow, where fluid passing through the meter body is measured by the mean velocity of the flowing fluid media. Flow rectifiers ensure a laminar flow in the axial direction of the wheel. A low-mass turbine wheel carried concentrically within the meter body is rotated by the fluid. The RPM of the turbine wheel is directly proportional to the mean flow rate within the meter body and directly corresponds to the volumetric flow over a wide range.
  • Sanitary Turbine Meters
  • " - 8" (4-200 mm)
  • -4-300°F ( -20 ~ +150℃)
  • 0.5%
  • 1 to 10 cSt
  • up to 150 psi (10 bar)
  • SS #316L (body) 2Cr13 or CD4MCu (rotors) Tungsten Carbide (Bearings)
  • 4-20mA, pulse, Modbus, HART
  • Sanitary Flanges
  • Clean liquids
  • Food and beverage
Refer to the link for more details: https://www.smartmeasurement.com/turbine-flow-meter-axial-turbine-meter/

 Inquiry - Turbine Flow Meter – Axial Turbine Meter (Sanitrary)