Low Cost Turbine Flow Meter – Axial Turbine Meter (ALTM-T)

Low Cost Turbine Flow Meter – Axial Turbine Meter (ALTM-T)

Share:


Low Cost Turbine Flow Meter – Axial Turbine Meter (ALTM-T)



Specifications

Sizes:
-8" (4-200 mm)

Accuracy:
0.5%

Temperature:
-4-300°F ( -20 ~ +150℃)

Process Connection:
Flanges (ANSI,DN,JIS) FNPT, MNPT, Wafer

Application:
Low viscosity fluids, DI-water, fuel oils

Viscosity:
up to 20 cP

Operating Pressure:
up to 3000 psi (25Mpa)

Material:
SS #304 or #316 (body) 2Cr13 or CD4MCu (rotors) Tungsten Carbide (Bearings)

Signal Output:
4-20mA, pulse, Modbus,HART

Process Medium:
Clean liquids


SMC’s low-cost ALTM turbine flow meters are used for the precise measurement of instantaneous flow rates of low-viscosity fluids such as tap and demineralized water, fuels, liquefied gases, light fuel oils, solvents, and pharmaceutical fluids. Turbine flowmeters measure volumetric flow, where fluid passing through the meter body is measured by the mean velocity of the flowing fluid media. Flow rectifiers ensure a laminar flow in the axial direction of the wheel. A low-mass turbine wheel carried concentrically within the meter body is rotated by the fluid. The RPM of the turbine wheel is directly proportional to the mean flow rate within the meter body and directly corresponds to the volumetric flow over a wide range.
  • Standard Turbine Meters
  • -8" (4-200 mm)
  • -4-300°F ( -20 ~ +150℃)
  • 0.5%
  • up to 20 cP
  • up to 3000 psi (25Mpa)
  • SS #304 or #316 (body) 2Cr13 or CD4MCu (rotors) Tungsten Carbide (Bearings)
  • 4-20mA, pulse, Modbus,HART
  • Flanges (ANSI,DN,JIS) FNPT, MNPT, Wafer
  • Clean liquids
  • Low viscosity fluids, DI-water, fuel oils
Refer to the link for more details: https://www.smartmeasurement.com/low-cost-turbine-flow-meter-axial-turbine-meter/

 Inquiry - Low Cost Turbine Flow Meter – Axial Turbine Meter (ALTM-T)